EUROLOGIC Voyager 3000 Guia de Instalação descarregar pdf (Página 136)

Using the RSN Software

6-6 Fault Tolerant System Administration (R1004H) HP-UX version 11.00.03

Checking Your RSN Setup

You can use the rsncheck command to display the configuration of your RSN

software and flags any errors. The rsncheck command performs the following

functions:

■ displays the machine name and site ID

■ checks that rsndbs, rsngetty, and rsn_monitor are currently running

and are set to respawn in /etc/inittab

■ ensures that rsntrans is enabled in /var/spool/cron/crontabs/sracs

■ displays the phone number and modem being used by the RSN software

■ checks that the protocol is RSNCP

The output of the rsncheck command lists any problems and the actions you can

take to correct them. The following is sample output:

# rsncheck

+=======================================================+

ERROR3: bridge system path is not set on chopin

Follow these instructions to set the

bridge_system_path:

Run ’rsnadmin’

Select ’local_info’

Select ’bridge_system_path’

Select ’set’.

Enter ’/’ if this is the system connected to

the HUB, otherwise enter the path of the

system connected to the HUB

Example: ’/net/machinename’

+=======================================================+

For more information, see the rsncheck(1M) man page.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 177 178

Sem comentários

EUROLOGIC Voyager 3000 Guia de Instalação Página 136